Hello all,Is it possible to convert a 2nd standalone switch to a single VSS (which does not have provisioned info about the second switch) without interrupting the service? I have searched through all the documentation but it does not explain at a lo...
Hello,
I have had an issue, where an ASR 1002-X 03.16.6S XE did not allow the incoming connections (telnet or ssh), without explicitly configuring the "exec" command under line vty..
This is a strange behavior, because first, it did not have "no ...
Hi Mark, I restored the VSS last week. This is how it went: 1. I did not have to reboot the single-VSS after I converted the second standalone chassis into VSS. Once I converted the standalone, it rebooted. After this the Active VSS got up the LMP an...
Balaji, I do not think that the running-config can help you to determine what is going to happen if I plug the second switch. It is more about the behaviour and the sync process of the VSS in general.
Balaji, This is the Active one. SW1#sh switch virtualExecuting the command on VSS member switch role = VSS Active, id = 1Switch mode : Virtual SwitchVirtual switch domain number : 1Local switch number : 1Local switch operational role: Virtual Switch ...
Balaji, My project consists in restoing the VSS system which consists of an Active VSS single switch + a standalone switch, which a long ago was part of the VSS system.The Active switch seems like after the VSS got broken, was re-provisiones with th...
I forgot to mention that I do not perform convertion on both switches. I have an active VSS switch + a standalone one. However it seems that the Active has some info missing about the ports, which prevents me from doing a simple provisioning to the s...