About jimmlegs

jimmlegs · 04-27-2022

I have an issue trying to route from my PC at 192.168.150.202 successfully to 62.10.10.66. The 192.168.150/24 and 192.168.68.0/24 networks are connected via cross-connected sites using the 172.30.254.0/29 network to communicate.62.10.10.66 and 192.16...

jimmlegs · 03-12-2022

I am unable to route from my primary network to any sub-interfaces. I am attempting to segment the network and have created some /30 networks but I am unable to route to them. I have an ASA connected to a Meraki MS250-24P, my primary network is 192.1...

jimmlegs · 07-19-2019

Good Day, I am having issues with my ASA configuration and have thus far been unlucky in determining a solution. I have a bunch of hosts in a DMZ and a couple of client nets that they need access to. I need to route and allow traffic from hosts in th...

jimmlegs · 06-14-2019

I am trying to change my configuration to serve my network's public IP and DMZ from subinterfaces on the same physical interface. When I configure the public IP address directly on the physical interface I have Inernet access as expected but when I c...

jimmlegs · 06-13-2019

Any ideas why I cannot SSH from any clients on the 192.168.68.0/24 network to the inside interface IP of the ASA?namesname 192.168.68.0 Net-NY2-SERVERSname 192.168.168.64 Net-NY2-NETWORKip local pool temppool 192.168.0.10-192.168.0.15!interface Gigab...

jimmlegs · 04-28-2022

Thank you Jon! Once I added the route on the switch and applied the correct ACL to the interface I am able to communicate end-to-end as required.I am forever greatful.

jimmlegs · 04-28-2022

Would TCP connections work? I'm not too concerned with ICMP. Thank you. I will try this tonight after business hours.

jimmlegs · 04-28-2022

FIrstly, thank you for all of the assistance and guidance provided so far, this issue is beyond my ability and Cisco support is not helping much. The issue isn't yet fixed but I believe progress is being made. Unfortunately adding neighbor 192.168.68...

jimmlegs · 04-27-2022

Just for completeness I wanted to post the results of sho bgp ipv4 uni 192.168.150.0 from the remote device sho bgp ipv4 uni 192.168.150.0 BGP routing table entry for 192.168.150.0/24, version 840 Paths: (4 available, best #3, table default) Multipat...

jimmlegs · 04-27-2022

Yes, "192.168.150.0 192.168.68.253 0 0 65518 i" is from the BGP neighbor My ASA shows show bgp ipv4 uni 192.168.150.0 BGP routing table entry for 192.168.150.0/24, version 3827 Paths: (1 available, best #1, table default) Advertised to update-gro...

Member Since	‎05-05-2019 11:04 AM
Date Last Visited	‎11-22-2022 06:25 AM
Posts	40
Total Helpful Votes Received	30

User Statistics

User Activity

Routing/BGP Issue

Cannot Route Between Subinterfaces

Help With ASA Configuration

ASA Subinterface Configuration Issues

Cannot SSH To Inside Interface From Subnet

Re: Routing/BGP Issue

Re: Routing/BGP Issue

Re: Routing/BGP Issue

Re: Routing/BGP Issue

Re: Routing/BGP Issue