Dear all, I have a Finger Print device which is connected to the LAN and it has Static IP Address, SM, DG, and DNS. in this device, i typed the address of the dyndns which is http:// xxxx.dyndns.org:9650/ The issue is: the device cannot connect to th...
Dear all,I want to install Cisco 2702i inside a Coffee Shop. the owner asked me to do this service once the customer take their dine in order. Furthermore, she needs also Time Limit, say for example 1 hour usage after that it is disconnected from the...
Dear all,I have set up at home Cisco 2702i Series AP. My PC has a Wireless NIC with two Antenna and the model is D-Link which supports ac.As you can see from the picture, the speed is 54 Mbps, how can i increase it to the maximum with good performa...
Dear All, I have setup AP 2702i, 3560G Swicth, and 800 ISR Router. Wired users are in VLAN7 > Network: 192.168.7.0 /24 with SVI 192.168.7.10 The Router is the default gateway: 192.168.7.1 which is connected to the Internet.AP is connected to the Swic...
Dear All, Here is my issue, Firstly, i plugged the AP 2702i to the switch port model 3560G using RG-45 cable. When i logged into the Ap through the Web Browser, i saw this message as mentioned in the subject title.At the same time, i touched the AP f...
Mobility Express sounds perfect to the owner needs. Will look forward to the model 2800, 3800, 1850 which support the features.Thank you very much for all your replies.
Thank you very much for your reply. I am looking for simple solution without using 3rd party, any idea please? Also how can I turn the Internet access On and Off during working hours in the coffee shop?
Hello pieterth,using the CLI you have mentioned solved my issue. i configured the power inline never on the port where it is directly connected to the switch and i connected the AP directly to the AC Power Adapter.I kept the AP On from yesterday till...
Hello cmarva, Thank you very much for your reply.Make sense, but recently i am using the power adapter, i remember Mr. Jeremy since CCNA R&S days has explained about the inline power and how to configure the port to use it. The label on the AP port i...
