About charlesyju

charlesyju · 05-14-2019

show mac address-table dynamic will display the vlan of the MAC. Is there an equivallent mib to get such information? I know the BRIDGE-MIB can get the MAC and the port from which the MAC is learnt. But it does not give the vlan the MAC belongs to.

charlesyju · 05-14-2019

I want to block a MAC address on a switch no matter which vlan the MAC belongs to. I saw similiar command as the following: mac address-table static 0050.3e8d.6400 vlan 12 dropHowever it requires a vlan parameter. How do I specify all vlans?

charlesyju · 05-13-2019

Does Cisco have a private mib to put a mac address into a blackhole so that the communication to the ip with the mac address can be blocked? A similiar MIB from Huawei is the HUAWEI-L2MAM-MIB and the related table is hwdbCfgFdbTable.What I want to do...

charlesyju · 05-14-2019

In my case, there are maybe many MAC learnt from a switch port and I need to block certain MAC based on some other detection method. Anyway, good to get confirmation that vlan is required for the cli command. I will see what is the best automated way...

charlesyju · 05-14-2019

The document says that "MAC ACL can be used in order to filter non-IP traffic on a VLAN and on a physical Layer 2 (L2) port." In my case, the traffic is ip traffic.

charlesyju · 05-14-2019

Thanks for your reply. I do not want to block the port as there are other mac coming through this port.So for the ACL, can I set it via snmp? If so, could you point me the related mib?And for the MAC address table, are you refering to the following c...

Member Since	‎05-13-2019 11:42 PM
Date Last Visited	‎05-15-2019 02:55 AM
Posts	6

User Statistics

User Activity

snmp euqivallent of show mac address-table dynamic

block access based on Mac Address for all vlan

Cisco private mib for mac address blackhole

Re: block access based on Mac Address for all vlan

Re: block access based on Mac Address for all vlan

Re: Cisco private mib for mac address blackhole