Buy or Renew
Buy or Renew
FredThompson0340
Level 1
Level 1
Member since ‎05-14-2019
‎12-20-2020
Recent Badges

User Statistics

  • 29 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
First Discussion
5 Discussion Posts
20 Discussion Posts
10 Discussion Posts
1 Reply
20 Replies
10 Replies
5 Replies

User Activity

SPA232d Incoming SIP Call not ringing

11-27-2020
I am trying to use the ATA for incoming/outgoing calls via voip.ms.The service shows as 'Registered' on line 1 and I can make outgoing calls, but incoming calls do not arrive/ring.The voip.ms portal shows that a busy signal is received.Is it possible...

SPA232D Dial Plan Suffix

07-07-2020
Does anybody know if it is possible to add a suffix '#' to all outgoing numbers in the dial plan?I would like to dial '01xxxxxxx' but I would like to the ATA to send 01xxxxxxx#. I am using a wireless modem/dialler for outbound calls and the dialling ...

SPA232D Call Forwarding

07-02-2020
Can anyone recommend a guide for using the ATA to accept calls from PSTN number and forward them via SIP to a different number?Is it possible to easily switch this forwarding setup off/on.Thank you.  Fred

SPA232D NAT Mapping Enable/Keep Alive

06-10-2020
I am using my SPA232D via my home network router, where it has a reserved IP address 192.168.1.X. My router receives a dynamic IP address from my ISP.I am using PSTN and one SIP account on my system with associated directing dialling plan.Should I en...

SPA232d access via home network instead of via Ethernet

06-07-2020
I am trying to access my SPA323D for programming via my home network address 192.168.1.XX instead of the ethernet 192.168.15.1. I have tried using bridge mode, but the ATA stops working correctly after a few hours.I ma using the system for PSTN and o...
View more
Community Statistics
Member Since ‎05-14-2019 09:28 AM
Date Last Visited ‎12-20-2020 10:33 AM
Posts 29