Dear Mark, thank you very much!I've already used this guide to add Iphone to CME 8.6, had no problem...

Ryan, thank you!Lets move our discussion here:https://supportforums.cisco.com/thread/2085370?tstart=...

Hello! I found post with deploying Cisco Mobile 8.1 on CME 8.6: http://ccierants.blogspot.com/2011/0...

Thank you for reply!Sorry, I wasn't clear enough. I'm running CME 8.6 on 2811, so it is a bit off to...

Hello!I found post with deploying Cisco Mobile 8.1 on CME 8.6:http://ccierants.blogspot.com/2011/05/...

Hi!I would like to know if there is deployment guide for Cisco Mobile 8.1 for Iphone with new CME 8....

Hello!I launched Cisco CP, after discovering status is "Discovered with Errors". The details showed ...

Paulo, please check telephony-service tftp-bindings.Thank you!

Hello!Hard reset didn't help, please see belowshow telephony-service tftp-bindings: gws1#show teleph...

Hello!Do you have some information about time of planned Cisco Mobile for the iPhone integration?

Well, CUCM is an Enterprise level, so it is not a cheap solution.I would change a phone model to E71...

Please see my answer here:https://supportforums.cisco.com/message/3221337

Hello!I had same problem with Nokia E72.Nokia Call Connect 2.1 is not supported on the CME, conseque...

any ideas what could be wrong here?

Please have a look:ephone 13device-security-mode nonemac-address 0027.0D3E.EF1Fmax-calls-per-button ...