About AndrewKeating4493

AndrewKeating4493 · 06-15-2019

Here's a simplified version of some of the issue I'm having: Switch “A” is a Cisco SG350 with layer 3 enabled and has 2 VLANs. VLAN 10 (192.168.10.0) and VLAN 20 (192.168.20.0).Switch “B” is also a Cisco SG350 and has just the single default VLAN wit...

AndrewKeating4493 · 06-18-2019

There is however IPv4 Forwarding Table entries that seem to have been created by the switch upon assigning the VLANs an IP address. Destination IP Prefix of the LANs network address to its own SVI IP address.One for each VLAN created. So with that in...

AndrewKeating4493 · 06-17-2019

So if I’m trying to setup a static route between a host on switch A, VLAN 20 (eg. x.x.20.22) and the SVI of switch B (eg. x.x.10.1)… Switch A is acting as the router so I would setup a static route with a destination of x.x.10.1 but I’m confused as t...

AndrewKeating4493 · 06-17-2019

There is no information entered in the static routing table. Is this an absolute requirement for the above scenario?

AndrewKeating4493 · 06-17-2019

That window makes perfect sense although I can't seem to find it on my GUI.I'm running firmware v. 2.5.0.79. Here's the closest I get to the window you are showing...

AndrewKeating4493 · 05-22-2019

On the IPv4 Interface page just hit the "Add..." button.Then select which VLAN you want to affect.Select the "Static IP Address" radio button and you should then have the ability to define an IP. On that IPv4 Interface page:You only use the check box...

Member Since	‎05-22-2019 02:28 PM
Date Last Visited	‎06-26-2019 12:04 AM
Posts	6

User Statistics

User Activity

SG350: not able to ping another switch across subnets with layer 3 enabled

Re: SG350: not able to ping another switch across subnets with layer 3 enabled

Re: SG350: not able to ping another switch across subnets with layer 3 enabled

Re: SG350: not able to ping another switch across subnets with layer 3 enabled

Re: SG350: not able to ping another switch across subnets with layer 3 enabled

Re: Set static IP on SG350-28P