I have obtained the CCNA and am working on furthering my knowledge. I have bought two brand new never ever used or even opened Cisco 2911 routers and six working Cisco 7945 ver 11 phones (actually bought eight but two are v14 and will not work with ...
I (thankfully) obtained the CCNA before the new exams were issued.I was planning on taking the CCNP - Routing and Switching 300-135, CCNP Routing and Switching ROUTE 300-101 and CCNP Routing and Switching SWITCH 300-115 next.But now those exams are n...
I have copied using FTP the config file to the Firefox FTP server.I have erased the config file on the switch.I have rebooted and only added the ip ftp username and password.I have copied the config file from the FTP server back to the switch. Even ...
I bought a Cisco 2523 device several years ago. I am now just getting around to using it. But alas, I cannot find a configuration or hardware guide. Or if you can tell me how to 'simulate' the 'cloud' as in the attachment. I have ten Cisco 1841 ro...
I am on page 198 of the Official Cisco Certification Guide for CCNA Routing and Switching ICND2 200-105.I am using actual hardware and my attachment shows how I am going to set up my hardware.My question is SW1, 3 and 4 each have two VLAN's each. Wo...
I would do show ip int brief. This will show all interfaces, their status and if they have an IP address, what the IP address is.If it is receiving an IP address by DHCP that is not in the scope for vlan 9, I would go to the DHCP source and look to ...
Nope, I tried copying the vlan.dat file to the TFPT server (I can copy the startup-config there). Still timed out.As for using a second switch in a VTP domain, yees but only IF you have more than one switch.I am assuming at this point the vlan.dat fi...
Not sure what you are asking.To make sure a port has access to a vlan, that switchport must be a membere of that vlan.By doing show vlan brief, you can see which ports are in which vlans. Before you make any changes on a switch that has the default ...
Ok, I went back and started over - it now appears to be working. R1#configure tEnter configuration commands, one per line. End with CNTL/Z.R1(config)#access-list 1 permit 10.2.2.5R1(config)#int s0/0/0R1(config-if)#ip access-group 1 inR1(config-if)#e...
