About ThorbenB

ThorbenB · 06-04-2019

I have two cisco catalyst 9300 series switches which are connected to each other over te1/1/1.The problem is that when I e.g. perform a reload on one switch (switch-01) I get an err-disable on (switch-02)ERR_DISABLE udld error detected on Te1/1/1, pu...

ThorbenB · 05-27-2019

Hello,is there any possibility to install a IOS upgrade/update without getting a command prompt with the install command?I do it like this:install add file flash:FILE.bininstall activate(And then comes the command prompt: This operation requires a re...

ThorbenB · 06-05-2019

Switch 1 udld intswitch-01# show udld ten 1/1/1 Interface Te1/1/1 --- Port enable administrative configuration setting: Follows device default Port enable operational state: Enabled / in aggressive mode Current bidirectional state: Unknown Current o...

ThorbenB · 06-05-2019

Switch 1 INTswitch-01# show run interface ten 1/1/1 Building configuration... Current configuration : 299 bytes ! interface TenGigabitEthernet1/1/1 description -> switch-02 XX no switchport vrf forwarding XX ip address 192.168.1.2 255.255.255.2...

ThorbenB · 06-05-2019

Switch-01 Versionswitch-01# sh ver Cisco IOS XE Software, Version 16.06.06 Cisco IOS Software [Everest], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.6.6, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyrigh...

ThorbenB · 05-27-2019

Unfortunately I am not able/allowed to change the mode to bundled mode.Is there any way or workaround for the install mode?

Member Since	‎05-27-2019 03:04 AM
Date Last Visited	‎06-08-2020 10:58 PM
Posts	6

User Statistics

User Activity

Port stays in err-disable state

Upgrading IOS_XE without command prompt

Re: Port stays in err-disable state

Re: Port stays in err-disable state

Re: Port stays in err-disable state

Re: Upgrading IOS_XE without command prompt