Hi, we are deploying the Cisco UCS E160D M2 with VMware ESXI 6.5.0 with RAID0 but getting the below error during boot:Please suggest.

Dear Expert,Hope all is well.One of cisco route 2921 reboot it unexpectedly and upon checking, we find out below result:cisco router reload reason bus error at PC 0xB0D0B0D, address 0x0.the firmware version: c2900-universalk9-mz.SPA.157-3.M8.binthank...

Dear Expert,One of my client is using Cisco UCCX12.5 for Predictive Outbound calling. is there any way to set the limit of connected calls in predictive campaign so each agent will receive the selected numbers of connected calls which will save numbe...

Dear experts,  Please advise me that how can i configure G711 codec for internal calls and G729 for external calls. The reason is, Conference now is not working and i found that it will work on G711 codec but currently i am using G729 in my network. ...

Hi Experts,  I am facing an issue with MTP.  We are using GSM based calling with CUCM and there are 2 different scenarios with MTP: 1- Media Termination Point required option is enabled in SIP trunk :if called number is invalid or Power off so I get ...