About philipplant

philipplant · 01-13-2021

Hello, I'm upgrading an FTD from 6.2.3 to 6.6.1 and keep getting the following errors in the logs: **********************************************************[210113 13:34:41:525] Starting script: 000_start/101_run_pruning.plentering scriptDraining di...

philipplant · 04-02-2019

Hello, I have a Firepower 2110 running a multi-context ASA 9.9(2) instance. The chassis is configured and synchronized with an NTP server, but the ASA clock is still wrong. I cannot find commands in the ASA instance to synchronize with an upstream N...

philipplant · 05-22-2012

Hello folks,One of my clients would like to migrate their VPNs from OpenVPN to an ASA solution, and their current configuration uses the 'allow-pull-fqdn' feature of OpenVPN. When they connect to the VPN, as well as receiving the usual list of split...

philipplant · 12-16-2010

Hi folks,We're running CME 4.2(0) with CUE 2.3.4. A CUE AA script handles incoming calls, and redirects to an internal extension if necessary.Please could you advise on the best way of creating a call queue on the CME to receive our redirected calls...

philipplant · 07-21-2010

Hi folks,I'm working on an IP telephony network with about a dozen phones, mainly 7911 and 7961. The CM is a 2801 running 12.4(11)XW6, with CME 4.2(0). Inbound calls to one number are auto attended with the option to speak to a member of staff. If...

philipplant · 04-02-2019

To answer my own post: patience is required!It took around 3 hours for the clock on the ASA instance to synchronize with the FTD chassis, which happened without any further configuration changes.

philipplant · 05-23-2012

Hi folks,Anyone able to advise on this, please?Thanks,Philip

philipplant · 04-04-2011

You're writing about a switch that operates at layer 2 which in Ethernet requires no acknowledgement. So long as the frame gets sent successfully, then I would imagine it would be removed from the TX buffer immediately. Reasons for it not being sen...

philipplant · 12-20-2010

Got it! I changed session target loopback:rtp to an actual loopback interface and it seems to be working :-)Yay :-) Thanks Paolo.Philip

philipplant · 12-20-2010

Thank you Paolo, it is no longer dropping the call but I just get dead air after the transfer. No output from debug with term mon either :-(Well, apart from "Dec 20 21:05:12.476: //15848//TCL :/tcl_PutsObjCmd: TCL B-ACD: >>> B-ACD Service Running <...

Member Since	‎03-08-2009 06:46 PM
Date Last Visited	‎01-14-2021 09:56 PM
Posts	27
Total Helpful Votes Received	5

User Statistics

User Activity

Errors upgrading FTD

NTP on 2110 ASA

Migration to Cisco ASA from OpenVPN

CME call queueing

CTI server is offline

Re: NTP on 2110 ASA

Migration to Cisco ASA from OpenVPN

Re: Output Queue Drops - 3560 - a silly basic question

Re: CME call queueing

Re: CME call queueing