About BoguslawKowalski3556

BoguslawKowalski3556 · 06-18-2019

HelloIm solving some task from subnetting.I got address and mask of S1 network and R3 routing table.I counted everything for S1 network and got stucked.What will be the address and mask of S2 ?.I assumed 192.168.128.40 (broadcast of P3 + 1),but im no...

BoguslawKowalski3556 · 06-03-2019

Hello guysI've been working on some project in Cisco Packet tracer for last few days.I build my network,set every addresses and conections between routers etc.Today I started dealing with metrics (Im using RIPv2 protocol in all routers) and I got a b...

BoguslawKowalski3556 · 06-04-2019

Ok I understood everything.Thank you for your helpRegards

BoguslawKowalski3556 · 06-04-2019

Hello,thanks for your reply,It helped me a lot with understanding how metric in RIP works.I only have last question.Which of these two lines defines that my route will be advertised ten router hop away only?route-map RED-CONN permit 10 ormatch addres...

BoguslawKowalski3556 · 06-04-2019

Hi,thanks for your ReplyHere's the whole command I enteredrouter ripversion 2network 173.23.11.80/28network 173.23.11.16/28network 173.23.11.32/28route-map 1 out eth1route-map 1 permit 10set metric 3Regards

Member Since	‎06-03-2019 01:27 PM
Date Last Visited	‎06-19-2019 12:35 AM
Posts	5

User Statistics

User Activity

Task from subnetting

What set metric command does in RIPv2

Re: What set metric command does in RIPv2

Re: What set metric command does in RIPv2

Re: What set metric command does in RIPv2