escomservices1
Level 1
Level 1
Member since ‎12-14-2012
‎08-18-2017

User Statistics

  • 15 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hello;My system is composed of: UC560 +2 cisco 6901 ip phones+ 2 cisco 7945 ip phones. I use CCA 3.2 (3) for the configurationwhen I started the setup with the telephony configuration wizard  , the system has detected only two phones cisco 7945. so I...
HELLO when I try to session CUE the system asks me to authenticate. when I use the default credentials  of the uc (cisco / cisco) nothing happens ans this is the Result; UC560 # service-module Integrated-Service-Engine 0/0 session Trying 10.1.20.2, 2...
Hello;I am working on a UC560.When I run the telephony setup wizard, it informs me that I have a problem and that I should reset factory default the system.When I try to reset the system from CCA i obtained this message "Reset Cue failed"I try to res...
Hello;I am working on a UC560.When I run the telephony setup wizard, it informs me that I have a problem and that I should reset factory default the system.When I try to reset the system from CCA i obtained this message "Reset Cue failed"I try to res...
hello;i have an ipbx cisco u520.i have 1 pstn line and 1 gsm gateway.When i call a mobile number and the line (gsm gateway)is busy , the call is established from the pstn line.i would like that the calls to mobile phone will be made only from the gsm...
Community Statistics
Member Since ‎12-14-2012 02:58 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 15