I've got a lot of lab files already set up in VIRL 1.Is it possible to use these files in the new CML-P directly or is there a way to convert/import them for use in CML-P? Thanks
One question I've often asked myself but haven't been able to find an answer to yet... When a switch enabled with STP boots up, all switch ports transition through a series of STP port states before finally reaching a forwarding state (for those that...
Not sure if this is a quirk with VIRL or my limited understanding with STP. My setup:Two trunk links exist between switches SW1 and SW2 and are not in an etherchannelVLANs 1, 10 and 20 are defined on both switches and activeBoth switches have defaul...
Not sure if this is a quirk with VIRL or my limited understanding with STP. My setup:Two trunk links exist between switches SW1 and SW2 and are not in an etherchannelVLANs 1, 10 and 20 are defined on both switches and activeBoth switches have default...
Hi AllI'm experiencing an odd issue with SLAAC in VIRL where an interface set to configure itself with a global unicast address via SLAAC is still able to do so despite the only router interface by which it could 'learn' an advertised prefix being in...
Hi TimThanks for coming back.My intention is to deliberately have a mini loop - caused by the two trunk link not being in a port channel - and see that one of the two trunk ports gets blocked by STP in each vlan. The correct behaviour would be that i...
Hi TimThanks for coming back to me. I've updated the post with spanning tree output from both switches to make it a bit clearer.SW1 is the root bridge for all VLANs with all ports forwarding as expected.My understanding is that SW2 should be blocking...
Okay L3 ports it is then. Regards the interface config for the L3 ports, where will they pick up DHCP address from? Will I need to configure a DHCP pool on a node within VIRL, or will leases be automatically served to them from outside of VIRL someho...
