About WonderBoy1990

WonderBoy1990 · 09-23-2021

Hi,I have encountered an issue which is for me is unusual. As seen on the diagram below (example only), I have router with sub-interface Gi0/0/0/0.30 which is connected to BNG1 and BNG2 via pseudo-wire. The problem is even if I have already configure...

WonderBoy1990 · 09-17-2021

Is there a command to know the date and time to when a nV satellite becomes an active or standby state in a particular host?

WonderBoy1990 · 04-17-2021

Hi, Can someone help me understand the effect of implementing metric in the address family ipv4 rather than in a specific interface.Please see below config for reference. router isis 123is-type level-2-onlynet xx.xxxx.xxxx.xxxx.xxxx.xxnsf ietflog adj...

WonderBoy1990 · 01-22-2021

Hi, Do I need to reload the router after deactivation of fully superseded SMUs? Thanks

WonderBoy1990 · 01-05-2021

Hi,It is possible in ISE to allow a particular group to enter configuration mode but can only do the shutdown and no shutdown? What could be the possible argument for such.Thanks!

WonderBoy1990 · 09-23-2021

I tried the command but there was no error message. Usually an error message appears like for example if there is an MTU mismatch.

WonderBoy1990 · 01-15-2021

Hi, This is great! Thank you!

Member Since	‎06-17-2019 06:30 AM
Date Last Visited	‎10-01-2021 02:15 AM
Posts	7
Total Helpful Votes Received	10

User Statistics

User Activity

Xconnect issue on BNG PW-Ether interface

nV Satellite Dual Homed

IS-IS IOS XR

Deactivation of fully superseded SMUs

ISE TACACS Command Sets for shut / no shut

Re: Xconnect issue on BNG PW-Ether interface

Re: ISE TACACS Command Sets for shut / no shut