I have configured my access switch interfaces with DOT1X authentication from Radius server. And my end host connected with these interfaces are getting their IP from DHCP server. But since my end host clients are not able to authenticate successfully...
I am below error on DC Cisco Nexus."The following routers experienced a large number of 'no routes' in the prior 24-hour period. The default value is 5000 'no routes' but may be different depending on device group settings. The 'no route' counter is ...
I am facing issue will tracing the IP of end host directly connected on my catalyst switch. But at the same time I am able to ping the same IP from other network and CORE switch. Even I was not able to trace the VLAN (L3 interface) IP also but after ...
I have 1 end host connected on access switch in VLAN 112 and VLAN 112 is created on CORE switch.Between access and CORE switch I have L2 distribution switch. MGMT IP on access and distribution switch is from MGMT VLAN 110.On CORE switch, IP 10.10.200...
Hello Giuseppe, Thanks for your observation. You are right I am running OPSF on this CORE switch. But this issue I am facing for all end host IP's belonging to same VLAN.
Sorry Balaji, sharing whole config will not be possible because it's production CORE switch. Please let me know if you need any specific relevant configuration
Hello Georg, I have VLAN110 created for management purpose and trying to trace IP of VLAN100. Also have default gateway configured. interface Vlan100description VMware Managementip address 10.10.115.2 255.255.255.128ip helper-address 10.10.100.14no i...
I followed the steps suggested by you, there is no ACL configured on interface. Also ping is working, facing issue only for trace. I think trace work on UDP so if you can suggest me anything from UDP blocking point of view.
