Hi all,Had a look around previous posts but couldn't find anything specifically for what I'm aiming to do.I have successfully tested two very basic EEM applets to shut/no shut an interface at specific times. However, this was done by specifying the i...

Hi all, Bit of a frustrating problem that I can't find much info on, hoping someone has run in to the same issue before! Details: - Running CPI v3.9.1- Trying to deploy a very basic LW AP config template to set the TxPower and Channel settings to 'Gl...

Hi there, I am about to upgrade to CPI v3.8 and I'm hoping that will provide a good level of detail about clients that I can pull out. We run another vendors APs as well and one of the nice features they have is that they can list what a clients capa...

Hi all, We are trying to set up some NIC throughput monitoring on the GigabitEthernet interface on our WLCs (8510s and 8540s), all running 8.3 code. My Dev team are saying they can't read the throughput as a pre-requisite for them is for there to be ...

Hi all, A bit of a strange question but my scenario is this: - I need to upgrade a few WLCs (HA SSO) from 8.3.x to 8.5.x. When I previously upgraded from 8.2 to 8.3 although I performed AP predownload (Flex), when it came to entering the reset-system...