How to enable ipv6 dhcpv6-pd on rv130 when use PPOEv6?Device Model:RV130PID VID:RV130 V02Current Firmware Version:1.0.3.55 Most of new router devices support IPV6 dhcpv6 prefix-delegation even when WAN use oopev6.but on rv130 when WAN enable IPV6 and...
We are using rv130 to connect internet. IPS offering internet connection via PPPOEv6 and IPV6 address. WAN port can receive IPv4 and IPv6 address. How can I config DHCPv6-pd ,so that on of my server on LAN can assign IPV6 address from ISP.
RV130 cannot shown ddns.asp after upgrade to 1.0.3.51When click dynamic DNS , blank page shown. and web management page hang. After 1 minutes later , page reset.
on RV130X_FW_1.0.3.28 the feature works well. But when do upgrade to FW 44 - 55, it's break.I really need the feature. Hope there a FW update to support this back. o(╥﹏╥)o
rv130 WAN port can get IPV6 address from ISP via PPOEv6 (and of course ISP told WAN port prefix length).The problem is LAN port and all devices in lan can not get IPv6 address from ISP's ipv6 prefix delegation,It's always FEC0……. I need LAN 's IPv6 a...
Oh, I found it. Sadly. My ISP provide IPv6 after PPOE dialup. and the option only affects WAN connection type is DHCPv6 mode. When I set IPv6 wan DHCPv6 mode and Prefix Delegation enabled. WAN port can not get IPv6 address from ISP. When I set IPv6 ...