About John.Mayer

John.Mayer · 01-31-2024

Hi I have the following scenario and little confused about the technology and topology that need to be used RTR1 and RTR2 are the service provider routers (CE), and the provider informed us that they have an active-active connection via BGP.The quest...

John.Mayer · 10-23-2023

Hi Basically, I'm trying to implement QoS between our WAN routers with NBAR (8-Class QoS). Currently, I'm running IP Nbar discovery under my interfaces to see what's running. Also, create a class-map for my apps.Our issue is we use subinterfaces betw...

John.Mayer · 09-20-2023

Hi AllI have a Cisco router with P-5GS6-GL PIM card and a LTE connection problem. it worked fine but after I rebooted the router and shut/ no shut the cellular interface, no connection came up and the profile stock was in an "INACTIVE" stateI thought...

John.Mayer · 08-16-2023

Hello Everyone Actually, I have a below network and looking for the best way to configure the spokes connection (ISR Routers) to my single hub (Cat8000v) I would be appreciated if I could use your experience to choose the better topology. Two differe...

John.Mayer · 07-27-2023

Hi everyoneJust have a quick question about configuring the DUal-Homed FEX with Nexus 93180, for every host which connects to the fex interfaces (like servers which have only one connection to n2k-2248) is there any ways to sync the running config be...

John.Mayer · 02-02-2024

I was informed by the provider that they want to configure EIGRP between our CE and core switch. I'm wondering whether it's possible to have Active-Active links on EIGRP or if I need to use route-maps to direct certain traffic to CE1 and other traffi...

John.Mayer · 02-01-2024

Hello everyone,I have a stack of Catalyst 9300 switches with the network advantage license and IOS-XE 17.6, and for service provider routers, I believe they should be ISR44xx. Both connections are from the same provider. As many of you have pointed o...

John.Mayer · 10-25-2023

so which method do you prefer to have a better QoS: using the manual class-maps based on NBAR or using the dscp tags?I need QoS to prioritize ms-teams (include voice and video), office365, Webex and http(s) over other traffics.

John.Mayer · 10-25-2023

what information do you need.at the moment I do the below:1. enable NBAR on my outgoing interface2. create class-mape based on my requirement3. create policy map to shape my traffic based on class-maps4. create a PARENT policy map with below configpo...

John.Mayer · 09-21-2023

Already checked, and there is no recommended firmware for IR1835, but I tried 17.12.1 and 17.9.4. unfortunately, both are the sameanother funny thing is if I write erase the configuration and bring up the router via setup, cellular will be up and run...

Member Since	‎06-25-2019 01:23 AM
Date Last Visited	‎03-01-2024 12:02 AM
Posts	35
Total Helpful Votes Received	2

User Statistics

User Activity

Active-Active Edge topology

QoS with NBAR (8-Class)

Cellular profile got inactive after reboot

Design recommandation for using VPN or SD-WAN

Cisco Nexus 9K (NXOS 9.3) Dual-homed FEX (FEX-AA) configuration

Re: Active-Active Edge topology

Re: Active-Active Edge topology

Re: QoS with NBAR (8-Class)

Re: QoS with NBAR (8-Class)

Re: Cellular profile got inactive after reboot