Is there any way of chaning the flash to Read/Write.I add addtional flash and when the router reboots, Is makes a second partition. One of which is Read Only) and I can not delete, erase or anything with it. I am using the Intel chip.

Can not get this module to work in the Cisco 2610XM router. Have tried 12.2.8 T and 12.2.15 T IOS. With the module install the router continue to re-boot. Is there a specific IOS need to get the router to recognize this module.

Hi, I am having some problems getting Terminal Service and FTP traffic to work over an ISDN link. I am using Dailer Watch to back up a T1 lease line. When I drop the T1 and ISDN dials up and routes are learn via OSPF. ICMP seem to work fine so doe...

If one side of a circuit indicates high utilization, should the other side indicate the same? Let say the serial interface on a 2610 router has a load of 221/255 and the remote side shows a load of 8/255, shouldn't they be equal? Or could this be t...

Is it possible to have the ISDN backup on a different router then the primary circuit? (Hardware Fail-Over)