I have two 2801 routers, when I connect them with a CAT-5 cable to each other, then show up / down. When I connect them to a switch, it shows up/up. Everything is set to auto on the interfaces. I have read some of the posts about nothing being pl...
We ran a longer known good cross-over cable to another router that we knew worked. Still had the same issue. We swap out the cable to straight-through and connect to a switch, the ports work, but when we go back to cross-over nothing.
Listen, I am not trying to Wind people up. We have over 14 routers and switches that we have up and running. This is the only set that has this issue. We put everything the same. I know we need a corssover to work on the Routers. As you can see ...
Good point, The top one was suppose to be .32/24 and bottom .33/24, had both up and swapping back and forth on the notepad. In the router itself they are correct. As you can see I have an IP address in both routers and Line Protocol shows its down...
So here are my Configs from each router. They both are showing the same issue. Router9#show runBuilding configuration...Current configuration : 1502 bytes!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno servi...
Hey Joseph, For some reason, the Routers I am working on to work with both types. Unless for some reason someone went in and disabled Auto Sensing on the router itself.
