About ManIDE661

ManIDE661 · 08-09-2021

Im' trying to hide my router from the internet by having all unwanted requests producing a timeout to the intruder. I have added access lists to block incoming connection requests.e.g: "deny tcp any any eq telnet log" I have also added to all my ...

ManIDE661 · 07-12-2021

I have a 1941 operating with a backup 3/4G Cellular and a primary WAN interface.My issue is related to the DNS from my 3/4G interface persisting well after the interface is shutdown. The Show hosts indicated 4 DNS entries when I'm running my primary ...

ManIDE661 · 06-15-2020

Good Morning. I have tried to investigate unauthorized access attempts into my router but cant conclude if I have a problem. Below is my log of the access attempts.the interest is the 3 "permitted tcp" messages. these look like external access attem...

ManIDE661 · 03-24-2020

I have the Cisco 1941 with a backup 3G service primary service in a PPPOE connection. Both interfaces are working, the 3G is dial on demand and it comes up when dialed.I have a 8 port EHWIC-D8ESGP which the clients are connected to, this interface w...

ManIDE661 · 02-16-2020

Cisco 1941 ISM-SRE-300-K9 cost feasibility Hello I’m looking to install the ISM-SRE-300-K9 into my Cisco 1941 Router with the AXP software and have a few questions.I will look at buying a used ISM with the AXP applications already installed and lice...

ManIDE661 · 09-10-2021

Hello. Below is my config I am using the "no ip unreachables" In my set up, is it in the correct location ? I have "ip telnet quiet" added as suggested but not sure its doing anything in my setup. !version 15.8!!boot-start-markerboot system flash0...

ManIDE661 · 09-10-2021

Yes I have the Zone command Ver15.8

ManIDE661 · 09-04-2021

I have followed up with more testing of my issues and this is what i found. using the commandno ip unreachablesIt provides a time out as needed.however this is limited to entries in my Access-list.ip access-list extended No-PINGpermit icmp any any ec...

ManIDE661 · 08-10-2021

I was using a friends laptop for testing it looks that this message "connection refused" was his client. as indicated aboveI have loaded putty now and we get "connection times out" for telnet connections I have a cisco 1941 running ISO 158-3.M3....

ManIDE661 · 08-09-2021

Hi.Yes this a home office.I don't need to access the router from outside or inside with telnet or SSH. I would like to hide the router.when I try and telnet into this router I get a "connection refused", just to be clear I don't need telnet or SSH...

Member Since	‎08-05-2019 04:14 PM
Date Last Visited	‎12-07-2022 12:03 AM
Posts	31
Total Helpful Votes Received	10

User Statistics

User Activity

Hiding Router on internet by dropping as opposed to denying packets

Cisco 1941 DNS Setup unwanted DNS servers entries.

Cisco 1941 External login: Is This a problem ?

Cisco 1941 with Backup 3G-hspa+7 Not allowing client traffic through to Backup interface.

Cisco ISM-SRE-300-K9 Running AXP on Cisco 1941 ISO Router.

Re: Hiding Router on internet by dropping as opposed to denying packe

Re: Hiding my Router From internet by droping as oppsoed to denying

Re: Hiding my Router From internet by droping as oppsoed to denying

Re: Hiding my Router From internet by droping as oppsoed to denying

Re: Hiding my Router From internet by droping as oppsoed to denying