About jeremyculver

jeremyculver · 05-27-2020

I have a Catalyst 2960-X 48FPS-L with an uplink in port 52 using a tranciever module which is connected using an ethernet cable to a Catalyst 2960G on port 4. The link has been working for a few weeks, however today it went down. Both ports show th...

jeremyculver · 05-28-2020

@mohammedshahidali88 The module is a genuine CISCO module. I have tried swapping out the module and that has no effect. The GLC-T module resides in the 2960-X, and i have tried connecting to different copper ports on 2960G with no difference. I ha...

jeremyculver · 05-28-2020

@Leo Laohoo Thanks for your response. I have upgraded firmware to 15.2(7)E2. Interfaces are both up. So now i wait to see whether it will remain up longer than two weeks (interfaces always goes down within two weeks).

Member Since	‎08-05-2019 11:14 PM
Date Last Visited	‎06-04-2020 01:46 AM
Posts	3

User Statistics

User Activity

Tranciever module port on Catalyst 2960X stops working

Re: Tranciever module port on Catalyst 2960X stops working

Re: Tranciever module port on Catalyst 2960X stops working