Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Vishal, Regarding following command,2) enter a command logging trap informational This is the default of IOS, that's why its not showing in the running config. You can verify it by using "show logging"
Very Interesting, i was searching for this issue and found that these could not be the reason for this issue as out of many vlan's why only one vlan is having loop problem.Move back to the SSH and start finding the cause. Interesting i found that the...
Hi Vishal,There's always a tunnel between AP and Controller, and clients traffic go directly to the controller through this tunnel. And from WLC it goes to network. So actually its transparent on the network upto controller. That's the reason you ca...
Hi,The static routes are like directly connected interfaces, even if your issuing the command redistribute static, only AD will be changed as it will be advertise as an external networkAlso whenever you will advertise this network to other eigrp neig...
Hi Sarahr202,Go to cisco website --> support --> downloadsor simply click here http://www.cisco.com/cisco/software/navigator.htmlHere you can seleck the products or technology,As per your requirements click products on the left coloum, then on the ri...
