Hello all you awesome people, I have 2 routers (1941) and 3 switches (3560) for my lab. Literally it's fresh out of the box, and all I've really done was setup telnet, DHCP, and messed around with port channeling and STP. Nothing more than "just to ...
I bought two 1841 routers as a lab and the setup is basic. Just these two routers, no switches yet. I plug them into each other and nothing happens. Not even a link light blink. Tried several wires and both ports on both routers. Nothing. I plug them...
I'm posting this in the same forum I found a similar issue. If this is the wrong spot, my apologies. I past my CCENT July 19, 2019 and I just wanted a soft copy so I got the $3 kit the next day (July 20) and today being Aug 12th, I still have no emai...
So I did a tracert to 10.0.0.1 - no problem. Tracert to 10.0.0.17, and for some reason the PC tries resolving that through my home router (dual ether ports). So why all the sudden it want's to resolve it through the home router when it worked fine ye...
I did the ip routing commando n the router like you said (but wouldn't that be on by default on a router?). The SVIs are setup on Vlan1. The other Vlans was just me playing with STP. They serve no purpose. Why point everything to to Sw1 .18 instead o...
I took R2 out of the picture since it was just relaying packets to R1. Please see attached picture on how the equipment is setup. The 3 switches are connected to each other and S1 goes to R1. All switches have gateway of 10.0.0.17. (R1 fa 0/0) but ca...
Deepak, I entered the command you said and the results are the same.All the switches have a default route to 10.0.0.1 which is the port my PC is hooked up to and it's able to ping it no problem.
A lot of replies already. You guys are awesome. I shut down R2 because it wasn't doing anything but relaying packets. I'm posting the config and a picture of a more detailed setup. Everything is still able to ping and telnet within each other, but ju...
