About franciscohs

franciscohs · 02-15-2011

I'm doing some redundancy tests for servers connected through CNA (only ethernet for the moment) to two Nexus 5010 switches with VPC. Test lab looks like the attached file. Additionaly, both Nexus 5K switches are connected through the management port...

franciscohs · 02-22-2011

Version is 4.2(1)N2(1a)The rebooted device is the VPC secondary.

franciscohs · 02-22-2011

I replied to an earlier message of yours and the message got in the middle of the linear looking thread. The message is higher in the thread. Anyway, my response was:Well, yes, that's exacly what I'm doing right now and I'm aware of the LACP limitati...

franciscohs · 02-22-2011

Well, yes, that's exacly what I'm doing right now and I'm aware of the LACP limitation.I still wonder if LACP would help thou. I just tried disconnecting the host from one of the N5K, leaving the VPC configured in both and if I reboot the device with...

franciscohs · 02-18-2011

Thanks, that's good info. For the moment we are using port channels between the Nexus and the ESX hosts, which doesn't allow beacons.In principle I used trunks, since I think this is the most consistent way of configuring the networking part of the s...

franciscohs · 02-18-2011

Darren, the ESX is set to use link status.

Member Since	‎10-20-2009 10:28 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7
Total Helpful Votes Received	10

User Statistics

User Activity

Access redundancy testing on Nexus 5000 and VPC

Re: Access redundancy testing on Nexus 5000 and VPC

Re: Access redundancy testing on Nexus 5000 and VPC

Re: Access redundancy testing on Nexus 5000 and VPC

Re: Access redundancy testing on Nexus 5000 and VPC

Re: Access redundancy testing on Nexus 5000 and VPC