Hi,I am trying to learn dot1q tunneling in GNS3 with IoS.  I created a scenario to connect PCs in VLAN2 separated apart with the following switches.  The master switch has to be configured to pass vlans 2,3 through vlan100. I am not able to ping PC1 ...

Hi, I use SG300-10PP and I am trying to configure using SNMP.  I was able to set the Admin Status of a port 2 to Up using the Snmp client tool 'SnmpSet.exe -v:2 -r:172.20.0.12 -t:10 -c:pqrs -tp:int -val:1 -o:.1.3.6.1.2.1.2.2.1.7.50' I am not able to ...

I have a router platform with STP enabled on it.  If I connect Router.Eth2 and Router.Eth3 to a single 8port switch, router blocks one port.  If I connect to two separate 8port switches, both of them are in forwarding state.I am using one Cisco SG300...

I am using one Cisco SG300. I am trying to simulate two unmanaged switches in the cisco managed switch using VLANs.Port 3 - VLAN 2 - AccessPort 4 - VLAN 2 - AccessPort 5 - VLAN 3 - AccessGlobal STP - DisabledI am trying to test STP of another device....