About Yaro7619

OpenVPN user authentication via RADIUS · 03-24-2020

Hello.I have successfully configured OpenVPN server and routing rules on my RV260. There is an option to authenticate users on RADIUS server in this router. So I prepared a configuration on my RADIUS server, and turned on Remote Authentication Servic...

Yaro7619 · 03-19-2020

Hello Everyone.I have successfully configured OpenVPN server on my router (LAN IP 192.168.0.3). VPN client connection works fine... almost. I am using Split Tunnel, routing client traffic destined to the following subnets through VPNoption in order t...

Yaro7619 · 09-30-2019

Hello everyone.Following this https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/RV260/Quick_Start_Guide/EN/RV260_qsg_en.pdfuser guide procedure, I have just used a paper clip to restore factory setting on RV260. The result is, bricked device. Af...

Yaro7619 · 09-12-2019

Hi all.I have a new RV260 router running on 1.0.00.16 system image.In short. First thing I need to do is connecting to a serial console of the device. I connected my device via the serial port on 115200,8, N,1. I think my settings are correct because...

Yaro7619 · 03-24-2020

You saved me a lot of time. Thanks a lot.After adding this attribute, authentication works fine.

Yaro7619 · 03-24-2020

Solved.It was a typo when adding route rule to my existing router.

Yaro7619 · 10-01-2019

Hi Sujoy.I would like to apologize ... for my last post. The whole situation was my mistake. After a short break and a cup of coffee, I remembered that I have 192.168.1.0/24 subnet in my network. So after restoring the default parameters of the route...

Member Since	‎09-12-2019 08:35 AM
Date Last Visited	‎03-31-2020 07:10 AM
Posts	7

User Statistics

User Activity

OpenVPN user authentication via RADIUS

RV260 routing OpenVPN traffic

RV260 factory settings

RV260 router configuration

Re: OpenVPN user authentication via RADIUS

Re: RV260 routing OpenVPN traffic

Re: RV260 factory settings