Dears,I installed the ACI simulator software in a VM following all the instructions of the simulator documentation.https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/3-x/simulator/install_vm/b_Cisco_ACI_Simulator_VM_Install_Guide.h...
Dears ,Please check as the ACI sandbox does not accept any simple action on it from yesterday ? even creation of a tenant returns "Error: 400 - the messaging layer was unable to deliver the stimulus (connection error, Connection refused)"
Hello Claudia, Thanks for your response. I did all default configuration except only VTEP pool because the default one is used in my VMs environment( Attached all initial config). I changed also the NodeID but no effect. Attached screenshots for the ...