Hi, I have configure HSRP to both my router(please refer to attachment for config). Scenario:15:32:46: %HSRP-5-STATECHANGE: GigabitEthernet0/0/3 Grp 1 state Active -> Speak15:32:56: %HSRP-5-STATECHANGE: GigabitEthernet0/0/3 Grp 1 state Speak -> Stan...
Hi. I have configured policy map on cisco ASR1002-X (2RU-X) police cir 210000000conform-action transmitexceed-action dropviolate-action drop but from my monitoring the traffic can reach 600mb.How to solve this one. Regards,NoobGuy
Hi Richard Burts,Thank for explanation. I think my case fall into second generality. The LAN side influence by HSRP and the WAN side influence by OSPF cost.Regards,NoobGuy
Hi cmarva, Config:Router 1: Primary/ActiveRouter 2: Secondary/Standby During the incident:Router 1: status change to standbyRouter 2: status change to active During the incident, the inbound traffic go through router 2 and outbound traffic go through...
Hi Jon, My monitoring monitor both the inbound and outbound, but only the inbound traffic swing to router to when router 1 status change to standby. I already attached the graph and simple diagram. Regards,NoobGuy
Hi Deepak, Q : Is it applied to any interface?A : Yes, it applied to the sub-interface Please refer to attachment for:show policy-map interface XXXXXshow policy-map xxxx Regards,NoobGuy
