I've created the bond on the NAS. But after I configure the switch the NAS locks up. At one point I see is "Failed To Establish ieee 802.3ad connection." Removing the LAG gets the NAS back online. I made sure LACP was enabled and the correct port...
New to this so please be patient. :)I created a simple vlan on an SG350 . Port 1 connected to Edgerouter. Port 2 connected to WAP. Port 3 connected to laptop1 (VLAN2) and Port 4 connected to laptop2 (VLAN3). No internet access on either laptop....
After I create a VLAN i can no longer access the GUI.port 1 - trunk connected to routerport 2 - access, PCThe switch is connected to an Edgerouter.I'm sure it's something simple, but I'm new to VLANs and can't figure it out.
Thanks for the replies! I have to stress that I’m new to this switch and setting up vlans. At this point I just want to confirm I have the VLAN configured properly which looks like I do. However, I’m not sure about the settings for the port conne...
The EdgeRouter allows me to create separate LANs. So I created 10.10.2.0 on eth1 of the first router to supply the other EdgeRouter in my lab. DHCP on the live router assigned the lab router 10.10.2.3. I created another LAN, 10.10.3.0, on eth1 of ...
Thanks again!! I ordered the RS232 to USB adapter yesterday. So, the reason for my questions is I have setup a lab environment to learn more about configuring an EdgeRouter and Cisco switch. My setup is below. I think have a grasp on the VLANs, b...
Sorry for being vague. So here’s my setup. Port 1 - routerport 2- PC1 VLAN 10port 3- PC2 VLAN 20 i want both PC’s to have access to the internet. I have port 1 as a trunk. But I’m confused in regards to tagged vs untagged trunk. Still a lot to l...