Step 1.- Connect your console cable and power up the cisco switch; then, hold down the MODE button for a few seconds until the initialize prompt appears on the screen.Step 2.- Once you see the prompt, enter the following command: flash_init.Step 3.- ...

Hi, Barnard!Try to Load iOS in this format c2960x-universalk9-tar.150-2a.EX5.tar

Here are easy steps:REMOVE POWER CABLE then PLUG it back again. PRESS & HOLD MODE BOTTON for 8 mins....... You will see something like this...CPU rev: BImage passed digital signature verificationBoard rev: 24Testing DataBus...Testing AddressBus...Tes...