Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an older switch which does not support Layer3 Ports (routed port). can I connect this switch using an SVI with another switch where the interface is configured as a routed port ?
Thanks for the input Joseph. Part of he reason for using the routed port was because STP is disabled. But, the manual fail over is something to think about.
Thanks again,
Patty
Thanks Carlos,
Both switches have layer3 capabilities, It's just that one can only be configured with SVI does not have support for the Layer3 port "routed port" . So, on the core switch (the switch that supports "routed port") I wonderin...
