Hello again,
Thank you for your reply to my inquiries.
I would like to refer you to the following article:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/6-x/interfaces/configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS...
Hello,
Hope you are doing well.
From my understanding, the issue you are facing is in regards to the command:
"show interface vlan-id"not displaying "load-interval" as a valid keyword as you attempt to obtain more information about traffic pas...
Hello SYGY,
Hope you are doing well. After reviewing the discussion, I can see that you are running code: 6.0(2)A7(2) on your Nexus 3548.
Unfortunately upgrading from this code, as described in the article below:
https://www.cisco.com/c/en/us/...