I have a problem to connect my WAP200E to SW2960. What is my mistake?Both are POE. I connect only Wap200e to SW2960 and I check the 15.4watts, but I suposed that WAP 200E doesn't respond, because WAP 200e doesn't turn on.I need to put to grown, or p...
I have that problem to Cisco IP Phone 7942. I want to configure SNR in Cisco Ip Phone 7942, I have a CME 9.0. When I press Mobility Softkey, the Cisco IP phone 7942 doesn't make call. what is my problem. I show a part of configuration ok. I make some...
I have a little problem with SIP GATEWAY TO SIP GATEWAY. I have that topology of net:FXS=========SIP GATEWAY====ISP====SIP GATEWAY========FXS101 201CME Ai...
I have that ...hostname CME_B!boot-start-markerboot system flash:c2801-ipvoicek9-mz.151-4.M2.binboot-end-marker!no aaa new-modelnetwork-clock-participate wic 3network-clock-select 1 E1 0/3/0dot11 syslogip source-routeno ip dhcp use vrf connected!ip d...
I probe to Power injector both WAP 200E and I try to connect to the power injctor to Sw2960, but I dont have good results. I don't have another Switch whith poe, but when I put other devices like 7942 Cisco Ip Phone the Switch 2960 respond fine. The ...
I have that version SW 2960Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 26 WS-C2960-24PC-L 12.2(50)SE5 C2960-LANBASEK9-MCisco IOS Software, C2960 ...
Yes I connecto other device to switch 2960, and that switch responde fine, when I connect the device WAP200E I recive that message in the switch 2960 tstart error detectedwhen I connect the WAP 200E
