I have a centurylink dsl modem in bridge mode connected to my cisco2821 at my home office. Everything was working fine while I was using dhcp on WAN interface. Problem started when I decided that I needed a static IP. Primary reason was for secur...
I finally got it working last night off of some articles I found online. I tried altering my ACLs at first, but that did not help. First I went simpler with a standard ACL and when that didn't work I created an extended that allowed NAT but denied ...
It looks like the problem is definitely NAT related. Not sure where to go from here...Here is some debug output.
*Apr 7 00:59:58.651: mapping pointer available mapping:0*Apr 7 00:59:58.655: NAT*: Can't create new inside entry - forced_punt_flags:...
So when I got home yesterday, I took my dsl out of bridge mode so I could remove the Cisco from the mix. The connection would not work with the static. After working with Centurylink for almost two hours, they found a provisioning problem with the ...
