About guy.zwerdling

guy.zwerdling · 08-07-2019

I build recently some lab that contain 5 routers:R1R2R3R4R5 = ISP router the topology is sort of Hub and Spoke which my R1 is the hub,I setup on R1 IKEv2 Policy which use some proposal that contain the following:encryption aes-cbc-256integrity sha1gr...

guy.zwerdling · 09-01-2016

Hi guys,I apply some dACL that need to redirect unauthorized machine to "self-registered guest portal"I can see that my dACL applied successfully on the switch port (c3750 interface Fa2/0/8) but it doesn't redirect the machine to the portalAny sugges...

guy.zwerdling · 08-30-2016

Hi guys,I try to understand something about Authorization Policy and implement it on my LabI have Lab environment in GNS3 that I connect to physical switch c3750,On that switch I setup the port Fa2/0/7 as follow:interface FastEthernet2/0/7 switchport...

guy.zwerdling · 08-29-2016

Hi guysI have AnyConnect on some PC in my lab and I setup new wired network named "test" with 802.1x EAP-FAST with using password for authentication,If I try to connect using "test" network it doesn't asks for the username and password, and it justDi...

guy.zwerdling · 08-26-2016

Hi guys,I this error messages on my win7 machine:SW1_c3750#00:23:47: %LINK-5-CHANGED: Interface FastEthernet2/0/7, changed state to administratively down00:23:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/7, changed state to dow...

guy.zwerdling · 01-26-2020

The is a way to find out the sender for that attack?

guy.zwerdling · 08-07-2019

I don't know why I forgat to specefied those command in the configuration files,but even then with those command still I have the same issue,I post here the debug I am running.To start an event I run shut/no shut the interface Tu0 on R2.

guy.zwerdling · 09-01-2016

Hi guys!Big thanks so much!!I had some rule (policy>authorization) that was before my rule named "Basic_Authentication_Access" with "PermitAccess" and my device authorize by that rule and not my the rule that I make:So I delete my rule and on the "Ba...

guy.zwerdling · 08-31-2016

I setup again DACL, and the results are the same, the ACL doesn't implemented on my switch..What I missed?

guy.zwerdling · 08-31-2016

Hi howon,The AnyConnect doesn't prompt me the "trust certification" message, and I see the access reject on my swicth: What I need to do to force him to prompt this message?my live log:

Member Since	‎04-07-2016 09:08 PM
Date Last Visited	‎02-03-2020 02:39 AM
Posts	18
Total Helpful Votes Received	16

User Statistics

User Activity

IPSEC(ipsec_process_proposal): invalid local address

Redirect dACL doesn't work

ISE Authorization Policy

AnyConnect

Authentication result 'no-response' from 'dot1x'

Re: Directory Harvest Attack Prevention Problem

Re: IPSEC(ipsec_process_proposal): invalid local address

Re: ISE Authorization Policy

Re: ISE Authorization Policy

Re: AnyConnect