From the "Cisco Nexus 5000 Series Hardware Installation Guide", I see that for 5010 model switches, "the chassis supports hot swapping of the expansion modules."  This makes me think that if the switch was booted up with a module in place and it then...

I have two Nexus 5010 switches setup with vPC.  I have two Nexus 2148T FEXs, each one is connected to one of the Nexus 5000s.  I have a Dell M1000e blade chassis with 4 blade switches installed.  The A1/A2 IO slots have PowerConnect M6220 1G switches...

I think I have a handle on how to setup vPC on the Nexus 5010 and attached Nexus 2148T FEXs so that any server directly attached to them can have a vPC setup across the two switches/FEXs. But what about the blade servers in the blade chassis behind t...

If your switch infrastructure is solely two Nexus 5010 switches and two Nexus 2148T fabric extenders, is it possible to setup vPC?I had tried doing this and seemd to be running into issues with the peer detection.  I have switch SW-A with one attache...

The ability to auto-negotiate between 100 Mbps and 1 Gbps that the Nexuws 2248T has -- is this a hardware difference between the two (assuming so) or a firmware upgrade.  Curious to see if other than replacing hardware, there is a way to get 100 Mbps...