About helexis

helexis · 11-02-2010

I have installed the TabSyncInstall.exe program and configured the server settings and the user settings.I get the following error message: Unable to login (user) with configured password.I have tried using both the server name and the server ip addr...

helexis · 10-13-2010

The Package(s) Selected for Install :Cat3560Installation failed for product [Resource Manager Essentials] with message : com.cisco.nm.xms.psu.packagemgmt.InstallerException: Repository in use. Another Package Support Updater client session may be mod...

helexis · 06-02-2010

NetConfig job failed:*** Device Details for xxxxxxxxx ***Protocol ==> nullMessage: Deploy failed.:nullJob Policies----------------------------------------------------------------------------------------------Failure Policy: Ignore failure and continu...

helexis · 11-05-2009

Processes TISDiscoveryJobDelete are down What is this process?

helexis · 11-04-2009

The new port and module groups for RME have attributes that require data from Campus Manager. The disclaimer states, "NOTE: The attributes that begin with "CM." return data only if CiscoWorks Campus Manager is installed on the CiscoWorks Server."Does...

helexis · 11-03-2010

Ok...so no that service wasn't running. So I started it. Should it be running on the publisher or the subscriber or both?However, after waiting several minutes for the service to get up and running I tried to synchronize again and authentication was ...

helexis · 06-02-2010

We are creating a 'User-defined Task' specifying enable mode with the command 'reload in 1:00 y'.

helexis · 06-02-2010

Ok now we changed the commands to:reoad in 1:00 y...and it is successful but we get an immediate reload. It ignores the 'in 1:00' parameter.Job log attached.

helexis · 06-02-2010

Attempted the above suggestion with the below results:ERROR:RME_CDL1022:Failed while locking the deviceJob ID: 2691 Owner: crbarke Description: test reload command on c3650crystal Schedule Type: ImmediateJob Policies----------------------------------...

helexis · 11-07-2009

Figured it out.If I am going to have certs with FQDN, I MUST use the FQDN when I configure the DCR master hostname.

Member Since	‎09-28-2009 03:28 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	90

User Statistics

User Activity

CUCM Address Book Synchronizer login fail

RME 4.3.1 Device Package install failed

LMS RME 4.3.1 Netconfig job Deploy failed

TISDiscoveryJobDelete process LMS 3.2

Port Groups in RME 4.3

Re: CUCM Address Book Synchronizer login fail

Re: LMS RME 4.3.1 Netconfig job Deploy failed

Re: LMS RME 4.3.1 Netconfig job Deploy failed

Re: LMS RME 4.3.1 Netconfig job Deploy failed

Re: DCR internal error in communication channel