I have the following scenario:Lets suppose the switch is an ISP that provides a VPLS service to connect the 3 routers so they can established an ISIS neighbor relationship. I want to make sure that the traffic from one PE to another PE goes first to ...
We are having problem with the DMVPN configuration. There is a Hub router and several spokes on the branchs. The spokes routers are behind a NAT devices so they have private addresses. When the Hub router build their dmvpn table use the private addre...
Someone knows what is the purpose of the config.text file that is stored in the flash memory and what is the difference between the startup config file that is stored in the NVRAM memory?
I am verifying the routing in a network and i see in the cef table that the field of interface appears as <recursive> so i am not really sure if this is a problem and the router are performing recursive lookups for each packet. The router are receivi...
When the hub router detects that the spoke is behind nat, it use the attribute N and the public addres as the peer identifier. But in the router of our organization do not appear the N attribute.
I was trying to achieve this because i would like to extend the management network to other nodes that are not Cisco equipment, but i see that another approach is needed for this.
Thanks @Harold Ritter I am asking because I notice that in the network the latency has augmented significantly after MPLS was configured, and I think that could be that the routers has a wrong configuration or there is a process that should not be m...
