To all Cisco enthusiasts,
I am looking for a documentation about this matter I run into.
How come that I can not change the queue-limit in any of my Qos Classes to use byte based queue calculation and not packet based.
on ASR1001-X I can set Pack...
Dear Engineers,
I am facing a very odd situation.
I have a DMVPN network based upon 2 Hubs.
One of the spoke sites, - let's call it Site A - I work on, have two routers sharing the two same hubs.
The other site which is involved in my issue is ...
Dear All,
I have an issue with a LAP: cisco AIR-LAP1242AG-E-K9
Using the IOS: System image file is "flash:/c1240-k9w8-mx.124-25e.JAO6/c1240-k9w8-mx.124-25e.JAO6"
LAP#sh controllers dot11Radio 0 | i reset
Driver TX blocks: in use 0, high 0, at reset...
Dear All,
I am running into an issue with an old IOS and EEM script as I can't make it bypass the AAA.
So I have a script that should log into config mode and shut an interface if an event happens. Writing the script is not an issue.
But to make ...
Dear All,
I have an issue with a nice ISR4331 - My issue is on VOICE class we have a company standards policing to drop all traffic above the requested BW. Our CIR is 32MB - since we started to use ISR routers we have issues with the Qos. The only cl...
Hi,I have worked on this quite much. Recent isr4k iOS has the option to set bytes but only for the queue limit. For the WRED it is still not an option.Let's hope cisco fixes it soon.
Hi, for the IP SLA, you need to specify first the IP SLA-s operation type. like ICMP echo then you'll have your option just as you wrote, let me show you an example. (config)#ip sla 1299(config-ip-sla)#icmp-echo 1.1.1.1 source-interface lo 1(config-i...
Hi, Is it possible for you to have wireshark on the server? Also, you might have to span the port on your cisco switch which is connected to the edge switch. It might generate quite a lot of traffic but at the moment with this limited info, that is w...
Hi, the log messages have nothing to do with the EEM applet that you have provided. Most probably there is another script running to add these entries, maybe kron. Please mark this comment as helpful if it answers your question. Thank you
