I created a post recently with some issues with connected to switches via SSH. This was solved (but not entirely clear why) by removing the unnecessary configuration of SVI's. I still have two switches that I am unable to connect to via SSH. Topology...
I'm having an issue accessing a Cisco 2960x remotely via SSH. Basic Architecture is as follows Server --> Nexus 3K --> 2960x I can SSH from the server to 3K, and then SSH from Nexus to 2960x, but cannot directly SSH to the 2960x from server. The 29...
Thank you for your reply, Pleae find the output of sh ip ssh below SSH Enabled - version 2.0Authentication methods:publickey,keyboard-interactive,passwordEncryption Algorithms:aes128-ctr,aes192-ctr,aes256-ctr,aes128-cbc,3des-cbc,aes192-cbc,aes256-cbc...
Peter Thank you for your reply. If I test using ping from the sever with the options you describe, I can ping the swith with a MTU of 1472 but it fails at 1473 as it is required to fragment (as expected witht he additional 28 byte of headers). If I ...
So I think I have fixed the issue I've walked into this environment and have been trying to get this to work. I've realised there is no actual business reason to have the SVI's or the secondary address on VLAN 2001 and therefore removed them. Now w...
