Hi all,
We have a VG204 and VG202 device setup in one of our offices that we've recently deployed Cisco voice services to as part of a larger rollout company-wide. I've setup a number of these analog gateway devices for fax machine usage and they al...
All,
Having some issues adding a CUP server to a new environment we are building. Our CUCM publisher is version 11.0.1.20000-2 and we are getting the below trying to load up the first CUP server with version 11.0.1.10000-6. Not sure what to do to g...
Hey all,
We're looking to install a new v11.5 environment (CUCM, CUC, CUP, etc). Looking at the system requirements for Unity for example (some others show the same) and they show only ESXi 6.0. Will v6.5 work? Link below to what I'm talking abou...
I'm looking at the compatibility matrix and I'm a bit confused. There are a number of devices we have that I'm not sure if they are supported. I see 7###G on the list but the 7#### is not specifically listed. For example, we have a bunch of 7962 d...
Hey all,
I've been browsing through the forum here and Cisco support documents and I'm finding a lot of little hints as to what I need to do but am not quite seeing the whole picture. First off let me describe the situation and what we're planning....
We did a test dial out with an analog phone, no issues. When I dial into those numbers I get modem tones. The server supposedly used to work before plugged into the old phone system. Old phone system was an old 15 year old Alcatel with a few analo...
There's a server in that location with 4 modems in it, each modem is plugged into a port on the VG204. They are using them to dial out to customer devices offsite that have modems.
Attached is the current running config. Note: I have redacted some bits that were confidential and/or not relevant to this discussion.
When I look at each of the 4 ports on the gateway they all show registered.
Sorry, forgot to respond back after I got this working. You were right about it not being added to CUCM pub. I had added it but long story short I had reverted to the previous version and that wiped the few settings I had added including adding the...
