About bluebomb85

bluebomb85 · 10-23-2012

I followed the lab at (https://supportforums.cisco.com/docs/DOC-12534#comment-13921) to configure a gateway-to-gateway tunnel using RV042 version v4.1.1.01-sp at both ends. It seemes to be working, however communication seems to be limited to one w...

bluebomb85 · 10-31-2012

I'm having the same issue. We are wanting to change some advance routing on the device, mainly get rid of some routes it creates automatically. Anyway, we can access the telnet console however the username/password combonation isn't working. I have t...

bluebomb85 · 10-23-2012

That static address was the problem. However the way we filter internet for our users, changing this address allows them unlimited access to the internet. But I think we can figure that out. Thanks!

bluebomb85 · 10-23-2012

Also note that the router 172.16.18.1 has a route for 172.16.80.0/255.255.252.0 to 172.16.18.104. This is where I think I'm having a looping issue. Just not sure how to resolve it.

bluebomb85 · 10-23-2012

Here are some screens. Let me know if there is any other config you would like to see. Central Office Ip Config:Remote Office Ip ConfigCentral Office VPN ConfigRemote Office VPN ConfigCentral Office Route info

bluebomb85 · 10-23-2012

I took it out of the central office router, but now I'm getting a routing loop between the gateway router for our LAN and the VPN gateway router.

Member Since	‎10-23-2012 10:19 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Full Tunnel Config RV042

RV042 telnet access

Full Tunnel Config RV042

Full Tunnel Config RV042

Full Tunnel Config RV042

Full Tunnel Config RV042