About jeff_turl

jeff_turl · 11-01-2012

I am trying to run the following commands on a 2801 router, but the commands are missing:mls qos mls qos map cos-dscp 0 8 16 40 32 46 48 56The only QoS command i have in global config is (no MLS qos) :REMOTE-ROUTER1(config)#qos ? restore-show-output...

jeff_turl · 09-24-2012

I have a particular site that is causing me trouble, this site is connected in a back to back configuration using 2811 at CO and 2621XM at CPE. The CO end is also the CO for 3 other sites so has a total of 4 wics installed (WIC-1SHDSL-v2), these oth...

jeff_turl · 07-04-2012

I am trying to allow magic packets from our management servers to client PCs located over routed links. The management servers are on addresses 172.22.200.54/16 and 172.22.200.63/16They are directly connected to a 6500 to vlan 1 (GI 1/30 and GI 2/14...

jeff_turl · 03-12-2012

We use Nortel IP phones (1140E), according to the Nortel documentation Voice media is tagged by the phones as DSCP 46 and Signalling as DSCP 40.Can someone tell me where i have gone wrong! On my switch (3750) i trust the DSCP and have the cos-dscp ma...

jeff_turl · 03-12-2012

I was looking at ERSPAN to monitor VoIP traffic from a remote site (from VLAN300), the remote site has a 3750 (WS-C3750-PS-S) with one interface in routed mode that connects to the 6500 - again a routed port. The server that will be analysing the rem...

jeff_turl · 11-01-2012

Ryan, what i am (maybe mistakenly) trying to do is copy the same config off the current router on to the new router.all clients connect a 3750, which mas the cos-dscp map, which in turn is trunked to the router:3750mls qosmls qos map cos-dscp 0 8 16 ...

jeff_turl · 11-01-2012

It is set on the 3750, i was under the impression i had to also set it on the router as well?

jeff_turl · 09-25-2012

Thanks for that, turning on CEF on the WAN interface dropped the CPU right back down again when transferring large files.Regards

jeff_turl · 07-05-2012

Paolo, if the helper address goes on the interface that recives the broadcast, in this instance is that vlan1 that would need a helper address specified?Are you also saying i need to configure an ACL to be able to specify the port used for it to work...

jeff_turl · 07-05-2012

Soroush, i have about 6 client PC's that i need to be able to wake up so i was going to go to use broadcast since it will be the same management servers sending the magic packet, i thought it easier to do it this way.ThanksJeff

Member Since	‎10-06-2010 01:21 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	31

User Statistics

User Activity

MLS QoS map command missing on 2801

2811 with G.SHDSL WIC CPU running at 99%

Routing Magic packets

QoS policy for Nortel phones

ERSPAN 6500 SUP720-3B and 3750

MLS QoS map command missing on 2801

MLS QoS map command missing on 2801

2811 with G.SHDSL WIC CPU running at 99%

Routing Magic packets

Routing Magic packets