Dear Forum,We have an issue with a 10 Gig connection between a Nexus 5548 and a 3750X 10Gig. There is also a HSRP group running over this link with aggressive timeouts which recently behaves somewhat unstable. We noticed a bunch of CRC errors on this...
Hi, we had a similar issue and just resolved it. F5 was configured for Jumbo frame, but ISE by default is not. Also, we had no luck increasing the MTU on ISE 3.2. Maybe its just not working, maybe something else in the network dropped the jumbo frame...
Ok, will check out the video.. BUT we are using ISE 3.0. I dunno when this msg popped up. Maybe it was when we applied a hotfix to FMC or when we applied a patch to 3.0 (we see it on ISE 3.0 patch 5 and 6. FMC is 7.0)? It wasn't there when we first s...
Cat9k2 is also affected. This is a real pain. Customer had to use this feature to support voip devices that crash when sent an EAPoL msg (in a dot1x/mab NAC setup). Now they are basically lost and either cannot refresh their network HW or have to rep...
Hi Limlayhin, I'm confused as well, or at least I was. While everyone talks about EoS and - as was pointed out below - it might not be a wise choice to buy a 5500x in face of the FPR2100 and the new FPR1k devices at this time, Cisco managed to hide t...
The real problem behind this is not that you cannot install the old version on the new hardware,but rather that you can also not run 2.4 on the old hardware. That makes it basically impossible to migrate from an an existing to a new deployment. You e...
