curtmcgirt
Level 1
Level 1
Member since ‎11-04-2004
‎02-01-2021

User Statistics

  • 47 Posts
  • 1 Solutions
  • 20 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Accepted Solution
20 Replies
1 Helpful Vote
10 Replies
5 Replies
Certifications

User Activity

i have a 2921 router; pointing at a syslog server. the router has a loopback interface configured as the source of syslog. the router's gigabit0/0 interface has been flapping. i can see the up and down events for link and line protocol in the router'...
i have a 2921 router and a 4431 router. both of them have the vty config below.  line vty 5 15session-timeout 5access-class Internal in (the 4431 has a "vrf-also" here)exec-timeout 5 0transport input ssh Standard IP access list Internal10 permit 10.0...
this was a running router without g0 configured. i enabled it this way interface GigabitEthernet0description MGMT_INTvrf forwarding Mgmt-intfip address 10.2.0.5.255.255.255.0ip access-group MGMT innegotiation autoendip route vrf Mgmt-intf 0.0.0.0 0.0...
2921 router, acting as an NTP client and a DNS client. setting up NTP told me my ACL needs to allow NTP back from the NTP server into the interface. so i did the same thing with DNS. 10.160.12.135 is the IP of the local interface. i want the router 1...
my 3750 switch lets me use the command tftp-server usbflash0:c3750e-universalk9-mz.152-4.E10.bin but clients connecting to that server get "file not found." if i put the same file on flash: and change the tftp-server command to flash:, it works. is i...
Community Statistics
Member Since ‎11-04-2004 01:22 PM
Date Last Visited ‎02-01-2021 10:58 AM
Posts 47
Total Helpful Votes Received 15
Helpful Votes From
Helpful Votes Given To