davidlarsen

Hello!!Is it possible to program a button (hard og soft..), so that when it is pushed, the users tel...

Hello,Well, I sent a mail to support@cisco.com about this. -you cannot download this software unless...

Hello David,It is set to active...Anyway, everything seems to work now. The problem was some buggy i...

Hello!Can someone help me configure buttons to forward calls to analog wireless phones?Also can some...

Hello shtalukd,I sent you a private message... -still no go with downloading software.:-)-David

Hi David, :-)"Can you tell me if your Layer is set to permanently active or not?"-I'm not sure how t...

OkBut I already have a CCO id which is connected with my certifications... -and I can download files...

hello!!Just the same when I try to download from here:http://tools.cisco.com/support/downloads/pub/I...

Hello,I just bought 1 license for this software, and now have av valid PAK.I have some problems when...

Hello!!Sorry for late respons, but I was out off town... :-)When I call in now, half of the calls fr...

When I tested the uc560 against one single isdn test line earlier, it worked better. But I had just ...

I configured everything with CCA.Se the config in the attached file.The five first number in the pub...

I have installed the uc560 only with CCA. But when it don't work, I went to cli to watch and and pas...

Hello!I am in a process of changing telephone central from Alcatel 4200E to Cisco uc560 with 4 isdn ...