I have a CAT switch. When device connects to the port and port says Connected, MAC is not in the CAM table. It is a DHCP device Arping for it's address. It will connect with a forced renew or a reboot. Why is MAC not added to table? What can I tu...
If you work for management, they want a plan for replacements and it cannot be on a technology not yet implemented because those are special plans and special budgets. There needs to be a replacement plan in place for allocating budgets. Does anyon...
the set command is for catos devices. the other command would be like any other router... in config mode.interface loopback #ip adddress 192.168.x.x 255.255.x.xno shutdownWe typically use Loopback 0 for management but you can use other numbers.