Hi, I have a hyperflex cluster of three nodes with 2 x FIs. The VIC ports from the servers are connected to the Fabric Interconnects.I would like to use the two embedded (on the motherboard) Intel i350 GbE Ethernet ports but cannot see the hardware f...
Hi,
I am designing ACI connectivity to Palo Alto firewall in Active/Standby mode. Just have few queries -
1. will it be possible to create vPC to each Firewall and have an L3Out to each?
2. Is there any white paper regarding the connectivity to ...
Hi,
If the ACI fabric receives the same route through two different border leafs using two different protocol eBGP and OSPF, how does the non border leafs decide to take which path.
Link to any documentation would be really helpful
Thank you in ...
Thank you so much for your reply. I think This was a post long time agosomewhere 1.6 version But good to know that this has been added aftercouple of years.
Hi Manuel,
Thank you for your reply.
Have you done vPC to Active/Standby to Firewall pair and have L3out to those Firewalls?
In my scenario the Firewalls are in active/standby mode. Once the active firewall fails the secondary will take on that IP ...